Differences

This shows you the differences between two versions of the page.

--- installation [2022/03/31 23:14]
jan even clearer :')
+++ installation [2022/03/31 23:23] (current)
jan ...
@@ Line 15: / Line 15: @@
   * On the first //Wren// run you should set up the audio devices. This can be done from the main menu: setup/Audio devices.
-For a quick test you could drag in an oscillator module (Osc) and an output module (AudioOut). You can use ''Ctrl+F'' to find these modules quickly (they are on the first (I/O, pick the speaker symbol there) and second (Osc1, pick the leftmost sine symbol there) selector tab respectively).
+For a quick test you could drag in an oscillator module (Osc) and an output module (AudioOut). You can use ''Ctrl+F'' to find these modules quickly (they are on the first (I/O, pick the speaker symbol there) and second (Osc1, pick the leftmost sine symbol there) selector tab respectively). Also see [[add_modules | Add modules]],
-Turn down your volume a bit, as this may be loud otherwise, then connect the Osc's output at the bottom right corner to the AudioOut L 1 R inputs.
+Turn down your volume a bit, as this may be loud otherwise, then connect the Osc's output at the bottom right corner to the AudioOut's leftmost two inputs. Also see the [[faq#about_inputs_and_outputs | FAQ - ins and outs]].
-Next hit ''F9'', you should have sound now and the output level meter in strip 1 on the right side of the screen should indicate this. Hitting F9, again will stop the sound.
+Next hit ''F9'', you should have sound now and the output level meter in strip 1 on the right side of the screen should indicate this. Hitting ''F9'', again will stop the sound.
   * NOTE: to make the eSpeak text to speech module available it is necessary to install [[http://espeak.sourceforge.net/ | eSpeak]].

Wren Wiki

User Tools

Site Tools

Differences

Page Tools